Full auto GZL-45 rebar thread cutting machine

The full auto GZL-45 rebar thread cutting machine is used to cut thread on forged rebar end, which is very easy to operate.

1. Rotate switch “Clamp the cut/disentwine the cut” to “clamp the cut” position, and check whether it is normal to clamp the cut. Rotate switch “Clamp the cut/disentwine the cut” to “disentwine the cut”, and check whether it could disentwine normally.

2. Rotate switch “Clamp/Disentwine” to “clamp” position and check whether rebar could be clamped. Move switch “Clamp/Disentwine” to “Disentwine” position and check whether rebar could be disentwined.

3. Rotate switch “Manual/Automatism” to “Automatism” position.

1) Press the button “Automatic Start-up” to check whether machine could operate normally.

2) Check: automatic clamp - head rotate anticlockwise – go forward automatically – disentwine the cut automatically- head returns automatically - head stop automatically – clamp the cut automatically - the whole process is completed. Whether it is normal.

4. Adjust thread length: find the limit switch stopper, loosen the 8mm screw on the stopper, move stopper backward to lengthen, on the contrary, move stopper forward to shorten.

5. Adjust thread diameter:Loosen the four M10 nut on adjusting disk of machine head, with handle into the hole on adjusting disk to rotate. Rotate clockwise to reduce thread diameter, and rotate anticlockwise to add thread diameter. There are numbers from 16 to 40 on scale disk, keep the indicator on adjusting disk and size number on scale disk in one line if process one size rebar, and then fasten the four M10 nut on adjusting disk.